> Home>Signal Conditioners>Isolated Bus Input/Output System ISO-SLICE

Isolated Bus Input/Output System ISO-SLICE

Isolated Bus Input/Output System ISO-SLICE

New

The ISO-SLICE isolated Bus I/O system combines full three-port isolation with access to an industrial bus. 

More details

Industrial Ethernet Modules


Industrial Interface range of Ethernet modules allow virtually any process control variable or equipment to be connected to an Industrial Ethernet Network.

Isolated Bus Input/Output System

The ISO-SLICE isolated Bus I/O system combines full three-port isolation with access to an industrial bus.

This bus connects to the E-100, or Z-200 coordinator modules can then be used to transmit the process values via either Ethernet or RS232/485 wired communications or ZigBee wireless networks.

A wide range of modules are available, from a single universal input to 8-way 4-20ma units.

  • Universal Configurable input & outputs
  • Communicates to Ethernet / RS232 or
  • ZigBee Network Coordinator
  • Inter-channel & input/output isolation
  • Automatic Bus & Power connection via
  • DIN rail bus connector
  • Multiple inputs in one module
  • Isolated Transmitter Supply
  • Very High Accuracy, Low Cost
  • Only 12.5mm Wide on DIN rail

    Isolated Bus Input/Output System

     

    ParameterMinTypMaxComments
    Supply Voltage 12 24V 36Vdc  
    Supply Current (mA)   45 90 For 24 V dc supply (260mA for 50mS on start up)
    Bus Connection       16-bit bus connection
    Input Impedance (Volt)   1MΩ   Dependent on range (Typ=10V)
    Input Impedance( mA)   15Ω   Dependent on range (Typ=20mA)
    Volt drop (mA input)   0.3   At 20mA input
    Output Linearity Error   ±0.01% ±0.05%  
    Temp Coefficient     ±50ppm/ºC  
    Load Resistance Error     +/-5ppm/Ω 0 < RL < 750Ω
    Time Constant (10-90%) 25mS (fast) 60ms (normal)   Selectable fast/normal response
    Operating Ambient 0ºC   55ºC  
    Relative Humidity 0%   90%  
    Isolation Voltage see note 1 1kV      
    Surge Voltage 2.5kV for 50μS Transient of 10kV/μS  
    Notes Absolute maximum ratings indicate sustained limits beyond which damage to the device may occur. Accuracy figures based on 24Vdc supply, 4-20mA output with 250쀀 load and 20ºC ambient. Device is protected against reverse polarity connection.  
    Conditioner type Industrial Ethernet

24 other products in the same category: